PEPconnect

Luminos Agile: Table Accessories Video

This short video will cover common table accessories for the Luminos Agile 
Fluoroscopy system as well as how to put them on and remove them.

Now we'll discuss the commonly used table accessories first, the grip protection strip. First loosen the screw caps. On both sides and then pull it straight off from the top of the table. Then store it wherever you'd like. When you're ready, use it again. Just line the two ends. Up with the end of the table. Inside it on. It only goes down that far. Once it's on, tighten the screw caps again. Until the device is secure. Next, the lateral people left on the side of the table. In loop it over the side, then tighten the screw caps back down until secure. The third the single handlebar. Loosen it to remove it. You would have to remove accessories from one end, so I'll remove this one again. Time down into the correct position. Removing the footboard is easier than most people think. To remove it, walk up to the base of the table, grab the right side. When you squeeze the handle. Keep in mind that there's a pin in either end of the handle, so when you squeeze it, you had to retract both of those pins, squeeze it, lift it up, and then just remove the footboard. To put it back on the table, lift the left side up against the table pull type and then drop the right side down by squeezing the handle again. If you see Red poking out, it's not locked in. Pull it until you see green on the inside of the handle. Lastly, we will play with the lead apron on the tower. First, unpark your tower. What that out into the active position I can press it once and it pops it out, lock position and now I can just pull straight out from the tower to remove it to put it back in. I'll line both ends up to the tracks on the bottom side of the DT and then just push it all the way in. Until I click it. And it's locked into place. For now though, I want to and remove it so they can put the counterweights in the back of the tower. You can hang your light up on the hanger. And while you're back here, go ahead and grab your counterweights. Or place these. On the backside of the tower. Drop them both into place. And now when you move your tower around. It'll be balanced again.

SIEMENS Healthineers ' Luminos Agile Table Accessories Luminos Agile Agile Luminos Agile Agile Agile

  • agile