MULTIX Impact - Configuring Pre-defined Text Comments

MULTIX Impact: Configuring Pre-defined Text/Comments XPRF The following job aid can be used to save frequently used texts/comments as templates and se- lect them from the list as needed. 1.) On the “Service” Tab, select the “Processing Properties” icon under User Settings. Operation Patient Tool OGP Editor Clean FD FD Calibration Reconnect RIS Mapping Statistics Audit Trail Test Image Examination Tube Load User Setting Site Info. General Processing Exam Setting Postprocessing Properties Properties Image Register DICOM Disk Display Config. Properties Manager User Manager Service PMS Remote Remote DICOM Assistance Access Node FD Manager Sensitivity Print LifeNet PEPconnect Service Mgr 09:28:42 SIEMENS Unrestricted 0 Published by Siemens Healthcare GmbH © Siemens Healthcare GmbH, 2020 Healthineers Job Aid Effective Date: 05/18/2020 | HOOD05162003093384 Job Aid | Configuring Pre-defined Text/Comments Effective Date: 05/18/2020 | HOOD05162003093384 2.) To add a text item, enter the text in the “Add Comment box” and click “Add”. The text is added to the “Comments” list as a new entry. Image Processing Properties X General Comments Reject Reasons Add Comment Comments PA PA UPRIGHT Left CB Add Delete Close 3.) To delete a text item, select the item in the “Comments” list and click on “Delete”. SIEMENS Unrestricted 0 Published by Siemens Healthcare GmbH © Siemens Healthcare GmbH, 2020 Job Aid Effective Date: 05/18/2020 | HOOD05162003093384 Healthineers Page 2 of 3 Job Aid | Configuring Pre-defined Text/Comments Effective Date: 05/18/2020 | HOOD05162003093384 Please note that the learning material is for training purposes only! For the proper use of the software or hardware, please always use the Operator Manual or Instructions for Use (hereinafter co llectively “Operator Manual”) issued by Siemens Healthineers. This material is to be used as training material only and shall by no means substitute the Operator Manual. Any material used in this training will not be updated on a regular basis and does not necessarily reflect the latest version of the software and hardware available at the time of the training. The Operator's Manual shall be used as your main reference, in particular for relevant safety information like warnings and c autions. Note: Some functions shown in this material are optional and might not be part of your system. Certain products, product related claims or functionalities (hereinafter collectively “Functionality”) may not (yet) be comme rcially available in your country. Due to regulatory requirements, the future availability of said Functionalities in any specific country is not guaranteed. Please contact your local Siemens Healthineers sales representative for the most current information. The reproduction, transmission or distribution of this training or its contents is not permitted without express written authority. Offenders will be liable for damages. All names and data of patients, parameters and configuration dependent designations are fictional and examples only. All rights, including rights created by patent grant or registration of a utility model or design, are reserved. Copyright © Siemens Healthcare GmbH 2020 Siemens Healthineers Headquarters Siemens Healthcare GmbH Henkestr. 127 91052 Erlangen, Germany Phone: +49 9131 84-0 siemens-healthineers.com SIEMENS Unrestricted 0 Published by Siemens Healthcare GmbH © Siemens Healthcare GmbH, 2020 Job Aid Effective Date: 05/18/2020 | HOOD05162003093384 Healthineers Page 3 of 3