Omnia MAX Activating the System

Omnia MAX: Activating the System XP Turning on the Uroskop system • From the control room desk, firmly depress the ON button on the control panel. Allow 2- 3 minutes for power-up and diagnostic self-testing. ON S Control panel Note: The above steps will only provde power for mechanical table operation and will not activate the imaging system. Activating the Imaging System There are two was to activate the imaging system for non-radiology staff: • Emergency Registration – In the control ---- room, depress the F12 key on the top right- hand side of the control keyboard, this will activate the imaging system. An PRESS F12 TO ACTIVATE FLUORO & X-RAY FOR THE UROLOGIST IN AN EMERGENCY Emergency study is now enter in the F10 F11 F12 Prt So Sys RG Scroll Pause Lock Break System’s Patient listing along with the date and time of the examination. +Backspace Num Insert PyUp Lock Delete End PgDn Home Enter F12 button on control keyboard SIEMENS siemens.com/healthineers Healthineers . Job Aid | Activating the System Effective Date: 10/01/2018 | Quality HOOD05162002955103 Note: The imaging system is now activated for the physician’s foot switch, and the examination may begin. Patient data may be entered or edited at a later time, even if the system is turned off. • Manual Registration – In the control room, depress the F2 key on the top left-hand side of the keyboard to obtain the Patient Data entry screen (seen below). Enter all relevant data in the fields displayed; at the minimum all “bold” fields are mandatory and must be populated. Then select the Examination button at the bottom-left side of the screen. PATIENT INSTITUTION Lant Hama First Nom Wam P Dale orl IF ¥ | 1955 - Female 2.Other weight STUDY THAT Emergency Examination Prere-o ser Ok Cancel Examination Patient Data entry screen Note: The imaging system is now activated for the physician’s foot switch, and the examination may begin. Siemens Healthineers Services Page 2 of 3 Please note that the learning material is for training purposes only! For the proper use of the software or hardware, please always use the Operator Manual or Instructions for Use (hereinafter collectively “Operator Manual”) issued by Siemens Healthineers. This material is to be used as training material only and shall by no means substitute the Operator Manual. Any material used in this train- ing will not be updated on a regular basis and does not necessarily reflect the latest version of the software and hardware available at the time of the training. The Operator's Manual shall be used as your main reference, in particular for relevant safety information like warnings and cautions. Note: Some functions shown in this material are optional and might not be part of your system. Certain products, product related claims or functionalities (hereinafter collectively “Functionality”) may not (yet) be commercially available in your country. Due to regulatory requirements, the future availability of said Functionalities in any specific country is not guaranteed. Please contact your local Siemens Healthineers sales representative for the most current information. The reproduction, transmission or distribution of this training or its contents is not permitted without express written authority. Offenders will be liable for damages. All names and data of patients, parameters and configuration dependent designations are fictional and ex- amples only. All rights, including rights created by patent grant or registration of a utility model or design, are reserved. Copyright © Siemens Healthcare GmbH ………………………………………………………… Siemens Healthineers Headquarters Siemens Healthcare GmbH Henkestr. 127 91052 Erlangen, Germany Telephone: +49 9131 84-0 siemens.com/healthineers Published by Siemens Healthcare GmbH © Siemens Healthcare GmbH, 2017