PEPconnect

Replacing the Sample Port Video

This video provides instructions on how to replace the Sample Port on your RAPIDPoint® 500 System, including how to verify that the Sample Port is properly installed.

View the following video before you begin. When it's finished, replaced the sample port, squeeze the tabs and remove the sample port. Get the new sample port. Squeeze the tabs and install the sample board on the system. Release the tabs. Wiggle the sample port to ensure it's attached correctly. Touch the continue button. The installation is complete. The video is finished. Play the video again if you need help while replacing the sample port.

SIEMENS

  • video
  • replace sample port
  • sample port installation