PEPconnect

Processing a Sample Tube Video

This video provides instructions on how to properly process a sample tube on your Stratus® CS Analyzer, including adding the tube and TestPak to the instrument and starting the analysis.

To mix, gently invert the sample tube a few times and place the tube upside down in a cannula. Push gently until the tube snaps into place. Do not Pierce the stopper. Next, put the cannula in the sample manager an close the door. Place a new rotor with its opening up on the rotor table. Then place the test packs into the packmanager be sure the error on each test pack label point stored the instrument. Do not push in or touch the reaction paper. The strata CS can process up to four test packs at a time in any order. When all the checklist lights are out, the green start key lights up, simply press start and the test processing begins.

Sample/ Delete • Rotor Rotor Cup Sample Processing Pak Tips st • waste waste e Alarm Alarm

  • video
  • process sample tube
  • TestPak