PEPconnect

Sysmex UF-1000i™ Analyzer Processing Quality Control Video

This video provides instructions on how to process quality control  on the Sysmex UF-1000i™ Analyzer

Before you begin processing QC, make sure the instrument is in the ready state. The LED will be green. Select the manual icon from the main menu. Select the QC icon on the right side of the window. Choose the appropriate file from the list displayed and select OK. The QC measurement help Dialog box will appear with a summary of the steps to process QC. Mix EU F2 low control bottle that's at room temperature by shaking until there's no particle sediment at the bottom. Then shake vigorously another 20 times. Immediately after mixing within 10 seconds, dispense 0.9 milliliters of EU F2 control into a Cup. Within 10 seconds of dispensing, the control in the Cup, place the Cup below the aspiration pipette. Hold the Cup so the aspiration pipette is below the meniscus. Press the manual starts which hold the Cup in place until you hear 2 quick beeps which indicate the end of the aspiration. This will be preceded by 6 slower beeps. Discard any remaining control material in the Cup. The QC results Dialog box will display when sample measurement is complete out of range results display with a red background. Press accepte to plot the results on a QC chart. The LJ graph will automatically appear if it was configured in the IP you settings. Select manual from the toolbar to run the next level of QC. Congratulations, you've completed this exercise. Select the X to close the window.

Accept: The results will be CC02 cc02 accepted and plotted in the QC Select Close. chart Lot No. Congratulations. You have Select Accept. completed this exercise Select Re-analyze: The results will not the X in the upper-right corner to Shake a of a be accepted and you will be able at the shake close the window and continue. to rerun a fresh pour ot the 10 side of the to a the reagent acu control. Results are not plotted on Select Close. to drop tips into a the L-J chart 10 10 sæds) acu7 aci7 test tube into the start Cancel: The control results will This is be aborted. Scattergram: A scattergram of the QC analysis results is Set to Accept to URINALYSIS Make sure the instrument is Start to CSC data displayed in front of the QC in the Ready state. The LED Help Results window. will be green. -J t Error Sequence t Sequen

  • video
  • qc