Customer Self Service Video - Part 1
This video explains you how you need to install and use the following devices:
No audio included.
- Control device
meduser• ? meduser ? SIEMENS SIEMENS . Healthineers Please note that the learning material is for training purposes only. Healthineers For the proper use of the software or hardware, please always use the Operator Manual or Instructions for Use (hereinafter collectively Examinration "Operator Manual") issued by Siemens Healthineers. This material is to be used as training material only and shall by no means substitute Execute a function test of the STOP button: the Operator Manual. Any material used in this training will not be updated on a regular basis and does not necessarily reflect the latest Resume version of the software and hardware available at the time of the training. Monitor (only if not used Customer Self Service System is resuming The Operator Manual shall be used as your main reference, in particular for relevant safety information like warnings and cautions. Remote Assistance Wait until system is in standby. SIEMENS . SIEMENS If Monitor is used for diagnostic purposes, a monitor calibration Push the STOP button on the Haloriel Please note: Some functions shown in this material are optional and might not be part of your system. Disclaimer Instructions for diagnostic) Sink Stop button has been pressed or a system error has occurred. Control device Switch off the system control device Keyboard Please press Resume to continue. needs to be performed by authorized personnel A message window must be displayed on Certain products, product related claims or functionalities (hereinafter collectively "Functionality") may not (yet) be commercially available in your country. Due to regulatory requirements, the future availability of said Functionalities in any specific country is not guaranteed. Healthineers the monitor screen. Please contact your local Siemens Healthineers sales representative for the most current information. before you start Tools: Torx T20 screw-driver O Tools: none Click Resume (3) in the message window amination ation ixamination System Check Lock The reproduction, transmission or distribution of this training or its contents is not permitted without express written authority. Offenders Resume Total Time: 10 minutes will be liable for damages. System will return to standby. Request remote support to o n the system Switch on the system and wait SIEMENS Remote Support Required: NO Healthineers All names and data of patients, parameters and configuration dependent designations are fictional and examples only. perform the final installation Disconnect keyboard cable for system standby Install new keyboard and steps (Firmware Update) All rights, including rights created by patent grant or registration of a utility model or design, are reserved. Remove the GND (ground) wire Disconnect the cable Connect all cables Connect the GND wire Disconnect all other cables from the monitor and remove Switch off the system Connect the cable to the new connect cable to monitor Disconnect all other cables @ Siemens Healthcare GmbH 2021 control device old keyboard System Check Lock
- control device