PEPconnect

Sysmex UF-1000i™ Analyzer Adjusting Vacuum and Pressure Video

This video provides instructions on how to adjust vacuum and pressure on the Sysmex UF-1000i™ Analyzer.

Pressure and vacuum are monitored by pressure sensors. If any of these values exceeds the tolerance levels, an error is displayed. Let's look at how to display the instrument status for pressure and vacuum on the ipiu. In this case, the pressure value is too low. The relief valve should be adjusted to bring the value to 0.050 megapascals. Open the front cover. Locate the relief valve. Loosen the 0.05 megapascals relief valve lock screw. The pressure value was 0.40 megapascals, which is too low turn the adjustment nob clockwise to increase the pressure. While adjusting the pressure, watch the pressure displayed on the screen. Once the pressure value is 0.050 megapascal, tighten the lock screw to lock the adjustment nob. In this case, the vacuum is too high. The bellows vacuum regulator should be adjusted to bring the value to minus 0.053 megapascals. Open the front cover. Locate the bellows vacuum regulator. Loosen the locknut of the bellows vacuum regulator. The vacuum value was minus 0.065 megapascals, which is too high to decrease the vacuum turned the screw counterclockwise. While adjusting the vacuum watch the vacuum displayed on the screen. Once the vacuum value is minus 0.053 megapascal, tighten the locknut to the lock adjustment screw. Congratulations, you've completed this exercise. Select the X to close the window.

ujnnje Menu svys«s svBNs svBSNs Reset Select the select OK Data Log NO BLEACH! No, No Select the Select the Sensor icon Maintenance icon Select the Controller O pressure. 0 pressure. If the be adjusted Contact re resentative. representative. Contact r UF-1000i The pressure value will be The vacuum value will be indicated next to 0.05MPa minus Sheath - ammuoo pue esop pue esop ON u! X URINALYSIS aneu nox s eep e Is active. acuum Error MPa Error Press the start switch. 70 — start

  • video
  • adjust vacuum
  • adjust pressure